CrunchBang Linux

gosom

Member

Registered: 2012-11-27

Posts: 13

[SOLVED]Broadcom Corporation BCM4313 - System does not boot

I follow the instructions: http://wiki.debian.org/brcm80211 for Squeeze and it is installed succesfully.
Moreover after modprobe command I can connect to wirelles.

But when I restart the computer it does not boot.
It fails to an infinite loop of restarting.

command uname -a ouputs:
   

Linux mikro 2.6.32-5-686 #1 SMP Sun Sep 23 09:49:36 UTC 2012 i686 GNU/Linux

Why is it so difficult??

Last edited by gosom (2012-11-30 20:09:43)

sano

#! CrunchBanger

Registered: 2012-03-07

Posts: 111

Re: [SOLVED]Broadcom Corporation BCM4313 - System does not boot

Do you dual boot with (e.g.) ubuntu? I had the same problem as you whith this card when trying to use the proprietary driver in #! and the open-source one (+ firmware) in Arch. Try to reset the BIOS to defaults, that might get you a bootable system again.

Also, please post the output of

lsmod

gosom

Member

Registered: 2012-11-27

Posts: 13

Re: [SOLVED]Broadcom Corporation BCM4313 - System does not boot

Problem solved. I installed Crunchbang 11 and installed the drivers as in wiki.debian.org.